|
GREENLYT MARINE LED LIGHTS |
|
Seattle Washington USA PHONE 855-598-5337 |
|
Why GreenLYT Marine LED fixtures? Here’s a few reasons |
|
We’re different in a lot of GOOD ways - 1 GreenLYT Marine LED fixtures are INSTANT ON and INSTANT OFF – No 5 to 7 minute warm up due to vibration or generator outage (no light bulb to change "ever") 2- All LED parts and DRIVERS electronic components carry a 5 year warrantee 3- All wiring is marine grade waterproofed and sealed as well as shrink wrapped and bolts are tough gelled. Our glass is sealed with marine silicon. 4- All LED parts PUC/Heat Sink/Driver are individually replaceable – If one PUC (LED Unit) fails the fixture continues to operate. (You do not have to replace the fixture or circuit board) 5- We Electroless Nickel Plates our fixture cases and parts (not powder coat or an anodized finish which deteriorates quickly in salt water and will corrode) 6- GreenLYT Marine case are built from 5053 Aluminum and our hardware, brackets, bolts etc. from 316L STAINLESS STEEL – not zinc coated parts 7- Our Interior patent pending optic reflectors is 95% reflective Available as a FLOOD or SPOT 8- GreenLYT Marine use only Cold Phosphor LED modules. Heat hurts LED and leads to loss of light and life 9- Reduce Fuel Consumption up to 90 percent ENERGY REDUCTION. 10- Manufactured and built in the USA (Tacoma Washington) we're a veteran owned business. (Come visit us if you're in the neighborhood)
|
|
We’re not like anyone else - Most other marine LED fixtures rely on a single gasket to protect the most expensive part of your investment ; the LED module and the Electrical LED driver. Both of ours are individual IP66 rated (that means they’re dust tight and protected against heavy water jet spray). If this gasket fails on these other fixtures it means you’re out of luck— time to buy a new one. |
|
To Contact us about our Marine LED lights GreenLYT Marine —Seattle Washington—USA OFFICE: 855-598– 5337 or 206-364-5337
|
